This page was exported from Braindump2go Exam Dumps Free Download
[
https://www.pass4surevce.com
]
Export date: Thu Mar 28 18:29:00 2024 / +0000 GMT
2016/12 New Cisco 200-105: Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0) Exam Questions Updated Today! 100% Real Exam Questions! 100% Exam Pass Guaranteed! 1.|2016/12 New 200-105 Exam Dumps (PDF & VCE) 346q Download: QUESTION 191 A. ping address Answer: A QUESTION 192 A. exec Answer: C QUESTION 193 A. FF02::1 Answer: B QUESTION 194 A. The PVC is experiencing congestion. Answer: B QUESTION 195 A. The command establishes a static route. Answer: AC QUESTION 196 A. Corporate router Answer: A QUESTION 197 A. Visually verify the MAC addresses and then telnet to the switches to enter the switchport-port security mac-address command. Answer: C QUESTION 198 A. ::1 Answer: A QUESTION 199 A. 10.10.0.0/16 subnetted with mask 255.255.255.252 Answer: D QUESTION 200 A. FF02::6 Answer: B 1.|2016/12 New 200-105 Exam Dumps (PDF & VCE) 346q Download: YouTube Video: YouTube.com/watch?v=MPVtnwlwW3E
Free Instant Download 200-105 Exam Dumps (PDF & VCE) 346q from Braindump2go.com Today!
http://www.braindump2go.com/200-105.html
2.|2016/12 New 200-105 Exam Questions & Answers:
https://1drv.ms/f/s!AvI7wzKf6QBjgR8N2yzsALYPi7P6
Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?
B. tracert address
C. traceroute address
D. arp address
When using the CLI, which banner displays a message upon every connection that is made into
the router?
B. login
C. motd
D. slip-ppp
Which IPv6 address is the all-router multicast group?
B. FF02::2
C. FF02::3
D. FF02::4
Refer to the exhibit. What does STATUS=ACTIVE refer to in the output of the show frame-relay pvc command?
B. The Frame Relay switch is correctly programmed with the DLCI and is operational.
C. The router is actively broadcasting to establish a link to the Frame Relay switch.
D. The router is connected to the local Frame Relay switch, but not to the far end device.
The network administrator of the Oregon router adds the following command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command? (Choose two.)
B. The command invokes a dynamic routing protocol for 192.168.12.0.
C. Traffic for network 192.168.12.0 is forwarded to 172.16.12.1.
D. Traffic for all networks is forwarded to 172.16.12.1.
E. This route is automatically propagated throughout the entire network.
F. Traffic for network 172.16.12.0 is forwarded to the 192.168.12.0 network.
A network administrator would like to implement NAT in the network shown in the graphic to allow inside hosts to use a private addressing scheme. Where should NAT be configured?
B. Engineering router
C. Sales router
D. all routers
E. all routers and switches
A network administrator must configure 200 switch ports to accept traffic from only the currently attached host devices. What would be the most efficient way to configure MAC-level security on all these ports?
B. Have end users e-mail their MAC addresses. Telnet to the switch to enter the switchport-port security mac-address command.
C. Use the switchport port-security MAC address sticky command on all the switch ports that have end devices connected to them.
D. Use show mac-address-table to determine the addresses that are associated with each port and then enter the commands on each switch for MAC address port-security.
Which IPv6 address is the equivalent of the IPv4 interface loopback address 127.0.0.1?
B. ::
C. 2000::/3
D. 0::/10
The network administrator is asked to configure 113 point-to-point links. Which IP addressing scheme best defines the address range and subnet mask that meet the requirement and waste the fewest subnet and host addresses?
B. 10.10.0.0/18 subnetted with mask 255.255.255.252
C. 10.10.1.0/24 subnetted with mask 255.255.255.252
D. 10.10.0.0/23 subnetted with mask 255.255.255.252
E. 10.10.1.0/25 subnetted with mask 255.255.255.252
Which address is the IPv6 all-RIP-routers multicast group address that is used by RIPng as the destination address for RIP updates?
B. FF02::9
C. FF05::101
D. FF02::A
!!!RECOMMEND!!!
http://www.braindump2go.com/200-105.html
2.|2016/12 New 200-105 Study Guide:
Post date: 2016-12-06 07:27:33
Post date GMT: 2016-12-06 07:27:33
Post modified date: 2016-12-06 07:27:33
Post modified date GMT: 2016-12-06 07:27:33
Powered by [ Universal Post Manager ] plugin. MS Word saving format developed by gVectors Team www.gVectors.com